Waterworx Magazine
The New Laws for VOCs PDF Print E-mail
Waterworx
Monday, 19 March 2007 16:47
FEDERAL LEGISLATION 

The Minister of the Environment and the Minister of Health have developed a federal agenda to reduce emissions of volatile organic compounds from consumer and commercial products as annexed. They intend to develop and implement a series of measures between 2004 and 2010 to further protect the health of Canadians and the environment from problems associated with air pollution by reducing emissions of volatile organic compounds (VOCs) from consumer and commercial products.

BACKGROUND

Particulate matter and ground-level ozone are the main ingredients of smog and cause serious health effects for Canadians, including thousands of premature deaths, hospital admissions and emergency room visits every year. Recent studies have confirmed these negative impacts and shown that air pollution is also associated with an increased risk of lung cancer and heart disease. Up to two-thirds of fine particulate matter and almost all ground-level ozone are formed in the atmosphere from gaseous precursors. As a result, in order to address particulate matter and ozone, it is necessary to address the precursors as well.

VOCs are precursor pollutants contributing to the formation of ground-level ozone and particulate matter. Anthropogenic sources of VOCs include combustion and evaporation processes associated with transportation, the industrial sector, applications of paints and other surface coatings and general solvent use.

In recognition of the significant adverse human health effects of ozone and particulate matter, the Government of Canada and the provinces and territories, except Quebec, adopted new Canada-wide Standards for both of these air pollutants. These standards establish ambient target levels to be achieved by 2010: 65ppb in the case of ozone and 30 µg/m3 for particulate matter less than 2.5 micrometers in diameter. Achieving these targets will require significant reduction of emissions of PM, ozone, and their precursors, including VOCs. VOCs that participate in atmospheric photochemical reactions as precursors to particulate matter and ground-level ozone, were added to Schedule 1 (List of Toxic Substances) of the Canadian Environmental Protection Act, 1999 (CEPA 1999) in July, 2003 to make available a full range of management instruments under the Act.

Emissions of VOCs from solvents used in many consumer and commercial products constitute a significant source of anthropogenic VOCs to the atmosphere. The scope of consumer and commercial products is very broad and includes not only household consumer products but many products used commercially and in industrial operations. This vast universe of products ranges from underarm anti-perspirants, paints used in homes, inks used in commercial printing, and degreasing agents. While individually small sources of VOCs, in total they contribute significantly to the overall atmospheric loadings of VOCs and the associated ozone and particulate matter problem.

The Government of Canada’s Interim Plan 2001 on Particulate Matter and Ozone includes a commitment to develop an action plan to reduce VOCs from products. The $120.2 million package for clean air initiatives announced in the budget of February 2001 included resources for development and implementation of this plan, with additional resources for work on VOC-containing products included as part of the $40 million provided in the budget of February 2003.

To achieve domestic goals for ozone and fine particulate matter in some areas of Canada, transboundary measures are required to curb air pollution originating in the United States (U.S.). In December 2000, Canada and the U.S. signed an agreement to reduce transboundary air pollution in the form of an Ozone Annex to the 1991 Canada - U.S. Air Quality Agreement. The Ozone Annex commits Canada to take measures to reduce VOC emissions and contains specific commitments to take action to reduce VOC emissions from consumer and commercial products.

In October 2002, Environment Canada initiated consultations on the Federal Agenda by meeting with key industry stakeholder groups to ensure they were aware of the government’s intention to develop an action plan for consumer and commercial products and to encourage their participation in the consultation process on proposed measures. To facilitate stakeholder participation, Environment Canada developed a discussion document entitled Future Canadian Measures for Reducing Emissions of Volatile Organic Compounds (VOCs) from Consumer and Commercial Products to lay out the background on the various issues and to describe proposed actions that would serve as the basis for consultations.

In February 2003, Environment Canada distributed the discussion document to stakeholders, along with an invitation to a March 2003 consultation workshop. Over 55 representatives of industry, environmental and health groups, municipalities, and federal and provincial governments attended the workshop. All parties were invited to make presentations at the workshop and to provide written submissions outlining their views on the proposed actions. A workshop report was prepared by Environment Canada describing the major comments, points of view and proposals of participants and was distributed to all interested stakeholders. Environment Canada offered to meet on a bilateral basis following the workshop to further discuss their views and some industry stakeholders arranged meetings for this purpose.

Following a thorough review and full consideration of stakeholder comments, the Minister of the Environment and the Minister of Health have developed a Federal Agenda of planned measures and future initiatives to reduce emissions of VOCs from consumer and commercial products. In considering measures for the Agenda, particular attention has been paid to control actions in place in the U.S. to identify opportunities for utilizing similar approaches and strategies in Canada.

Measures under this Federal Agenda are part of the overall effort required to reach the CWS targets, and complement other initiatives, such as the measures outlined in the Federal Agenda on Cleaner Vehicles, Engines and Fuels and actions to be taken by provinces and territories. Federal Agenda measures to reduce VOC emissions from products will also deliver on the commitment under the Ozone Annex to the Canada-U.S. Air Quality Agreement to take action in this area. Consistent with CWS and Ozone Annex delivery dates, all measures specified in the Agenda will be implemented by 2010.

To read the full text please click on http://www.ec.gc.ca/nopp/DOCS/notices/voc/en/index.cfm

Last Updated on Sunday, 05 September 2010 13:52
 
AkzoNobel provides families with the gift of transportation

Norcross, Georgia -- December 20, 2011 -- Collision centres across Canada and the United States will share the gift of transportation with 25 deserving families and members of their communities during the 13th annual AkzoNobel Acoat selected International Benevolence Program, held December 12th through the 23rd. The Benevolence Program is a community service endeavour sponsored by AkzoNobel and conducted by collision repair centres that are members of the Sikkens...

Read more

3M pursues paint-free cars

London, Ontario -- December 12, 2011 -- 3M has signed a five-year commercial pact with a relatively new stainless steel and aluminum distributor to create a stable of so-called disruptive products, including technology that could eliminate the need for paint on automobiles. The partnership with Chicago-based Shale-Inland is the latest in a consistent string of acquisitions and joint-ventures that 3M has assembled in pursuit of reaching $50 billion in revenue. The M...

Read more

BASF announces new colour matching tool

Southfield, Michigan -- December 6, 2011 -- BASF Automotive Refinish today announced its COLOR-MAXmobile2 solid color tool. COLOR-MAXmobile2 is compact and portable and provides 531 colour chips in the palm of your hand. The chips are designed to be conveniently comparale to the vehicle with up to five colours on a single swatch. According to BASF, their family of COLOR-MAX tools is the most advanced colour matching system in the industry in terms of accuracy, co...

Read more

Practical paint tips from Standox for the cold season

Ajax, Ontario -- December 1, 2011 -- Athletes warm up before a competition. Motorists know that engine oil becomes thicker in the winter cold. Things are not all that different with clearcoats and hardeners, which also tend to become more viscous during the cold season if not stored properly. According to Standox, paint material should have a temperature of 20°C (68°F) to 25 °C (77°F) for spraying, as this ensures the best reaction between the clearcoat and t...

Read more

New low VOC clearcoats from DuPont

Ajax, Ontario -- November 2, 2011 -- DuPont Refinish has introduced three new, standard setting 2.1 VOC clearcoats designed for use with DuPont Cromax Pro basecoat. DuPont says it is excited to have these new clears which align with the needs of highly productive collision repair facilities.

Read more